Edge Cutting VERY Low

I like the feature, it makes sense to go around the boundary to trim the edges. However,  it trims the edges too much.

Is there way to cut the edges the same high as what we set?

WQ268741 just posted the same question yesterday!

Unfortunately this cannot be changed due to safety regulations. Because the blade pushes out so far to the side, Mova has to have the cutting disc low to the ground to prevent injury!

Good morning. The fixed 3cm cutting height of the UltraTrim edge trimming mode is determined by safety regulations as well as the robot’s mechanical structure.
According to safety standards, the rotating blades must be completely inaccessible to fingers while the lawn mower is operating. This requirement can be fulfilled in two ways: either by keeping a safe gap between the blades and the main body housing, or by lowering the ground clearance of the cutting deck guard.
To comply with safety norms, the ground clearance of the guard has to be reduced accordingly. This height adjustment is not configurable for the time being.
We suggest you turn off the UltraTrim function if you want the edge cutting height to be identical to the inner lawn height. Alternatively, you may adjust the general mowing height of the whole lawn to match the fixed 3cm height of UltraTrim edge trimming mode.

Thanks for quick response

If this is determined by safety regulations then I would offer a version without the ultra trim mechanicals to lower the cost and increase durability. Its unusable for many people.